Manual:HUMMER Hummer H3 Base 2010Page:15219 / 37523



Steering Wheel Inflatable Restraint Module Coil Replacement — 2010 Hummer H3 Base, Automatic Service Manual

Steering Wheel Inflatable Restraint Module Coil Replacement

Fig 1: Steering Wheel Inflatable Restraint Module Coil
GM2083266Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
  2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
1 Inflatable Restraint Steering Wheel Module Coil Bolt (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:  4.5 N.m (40 lb in)
2 Inflatable Restraint Steering Wheel Module Coil
Procedure: 
Disconnect any electrical connectors as needed.
Tip: 
  • The turn signal multifunction switch and the Inflatable restraint steering wheel module coil are serviced as an assembly.
  • Do not remove the centering tab from a new inflatable restraint steering wheel module coil until it has been installed or re-centering will be required.
  • If re-centering of the inflatable restraint steering wheel module coil is needed then refer to Inflatable Restraint Steering Wheel Module Coil Centering .