Manual:HUMMER Hummer H3 Base 2010Page:17185 / 37523



Cable Installation - Transaxle End — 2010 Hummer H3 Base, Automatic Service Manual

Cable Installation - Transaxle End

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Range Selector Cable & Range Selector Cable Bracket
    GM1900891Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure the range selector cable is routed exactly as originally positioned in the vehicle to avoid coming into contact with potential hazards such as hot, sharp, and moving objects.
  2. Install the range selector cable (2) to the range selector cable bracket. Ensure the range selector cable retaining tabs fully engage the range selector cable bracket.
  3. Install the retainer (1) to the range selector cable (2).
  4. Connect the range selector cable end (3) to the transaxle range switch lever.
    5. Fig 2: Left Heat Shield & Bolts
    GM1900888Courtesy of GENERAL MOTORS CORP.
  5. Install the heat shield (2).
    6. CAUTION: Refer to Fastener Caution .
  6. Install the heat shield bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    7. Fig 3: Shift Control End Of Cable & Transmission End Of Cable
    GM1900890Courtesy of GENERAL MOTORS CORP.
  7. Install the range selector cable retainer (4) to the transfer case.
  8. Install the range selector cable retainer (3) to the frame.