Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Raise and support the drive wheels.
- Support the lower control arms so that the drive axles are in a horizontal position.
- Start and idle the engine.
- Place the transmission in second gear and release the clutch pedal.
- Monitor VSS parameter on the scan tool. The VSS parameter should increase as the drive wheel speed increases.
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records List.
CAUTION:
Support the lower control arms in the normal horizontal position in order to avoid damage to the drive axles. Do not operate the vehicle in gear with the wheels hanging down at full travel.