Manual:HUMMER Hummer H3 Base 2010Page:20364 / 37523



Draining Procedure — 2010 Hummer H3 Base, Automatic Service Manual

Draining Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Fluid Drain Plug & Washer
    GM872959Courtesy of GENERAL MOTORS CORP.
  2. Clean away all dirt and debris from the transmission fluid drain plug area.
  3. Position an appropriate container under the transmission.
  4. Remove the transmission fluid drain plug and washer.

    Discard the washer.

    Allow the transmission fluid to drain into the container.

    5. CAUTION: Refer to Component Fastener Tightening Caution .
  5. Install the transmission fluid drain plug and NEW washer.

    Tighten:  Tighten the drain plug to 37 N.m (27 lb ft).

  6. Remove the container used to catch the used transmission fluid from under the vehicle.