Manual:HUMMER Hummer H3 Base 2010Page:20417 / 37523



Shift Control Housing Assemble — 2010 Hummer H3 Base, Automatic Service Manual

Shift Control Housing Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Shift Control Lever Assembly
    GM880940Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the shift lever plungers and the lever spring seat surface of the shift control housing with transmission fluid.
  2. Install the shift control lever assembly into the shift control housing.
    3. Fig 2: Shift Control Lever Retainer, Gasket & Bolts
    GM880937Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use a petroleum base or silicon lubricate on the shift control lever seals or boots. If a lubricant is required, use a water base liquid soap.
  3. Install the shift control lever shaft boot in the retainer.
  4. Install a control lever housing gasket to the housing.
  5. Install the shift control lever retainer.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the shift control lever retainer bolts and tighten to 20 N.m (14 lb ft).
    7. Fig 3: Control Lever Boot
    GM880928Courtesy of GENERAL MOTORS CORP.
  7. Install the control lever boot.
    8. Fig 4: Shift Control Lever Shaft Seal
    GM880926Courtesy of GENERAL MOTORS CORP.
  8. Install the shift control lever shaft seal.