Manual:HUMMER Hummer H3 Base 2010Page:21166 / 37523



Component Testing — 2010 Hummer H3 Base, Automatic Service Manual

Component Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate door jamb switch.
  2. Test for infinite resistance between the signal terminal 1 and the ground terminal 2 with the door jamb switch in the open position.
    • If not the specified value, replace the door jamb switch.
  3. Test for less than 2 ohms between the signal terminal 1 and the ground terminal 2 with the door jamb switch in the closed position.
    • If greater than the specified range, replace the door jamb switch.