Manual:HUMMER Hummer H3 Base 2010Page:23358 / 37523



Installation Procedure — 2010 Hummer H3 Base, Automatic Service Manual

Installation Procedure

  1. Clean any dirt or debris from the grommet sealing areas.
  2. Install the grommet on the sensor valve stem.
    3. Fig 1: Tire Pressure Monitor Sensor & Nut
    GM65676Courtesy of GENERAL MOTORS CORP.
  3. Insert the sensor in the wheel hole with the air passage facing away from the wheel.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the sensor nut and position the sensor body parallel to the inside wheel surface while torquing.

    Tighten:  Tighten the sensor nut to 7 N.m (62 lb in).

    5. NOTE: Before installing the tire on the wheel, note the following items to avoid tire pressure sensor damage upon tire mounting:
    • Position the mounting/dismounting head 180 degrees from the valve stem.
    • Position the bead transition area 45 degrees counterclockwise of the valve stem.
    • Using the tire machine, rotate the tire/wheel assembly clockwise when transferring the tire bead to the inside of the wheel rim.
    • Repeat items for outer bead.
  5. Install the tire on the wheel. Refer to Tire Dismounting and Mounting .
  6. Install the tire/wheel assembly on the vehicle. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.