Manual:AUDI A3 Premium, 4D Sedan 2015Page:31839 / 92758



Overview - A/C Compressor Power Unit, 4-Cylinder Engine — 2015 Audi A3 Premium, 4D Sedan Service Manual

Overview - A/C Compressor Power Unit, 4-Cylinder Engine

Fig 1: Exploded View Of A/C Compressor Power Unit, 4-Cylinder Engine
GWWA87-11380Courtesy of AUDI OF AMERICA, LLC
  1. Ribbed Belt
  2. Sub-Assembly Bracket
  3. O-Ring
    • Replace. Refer to the Parts Information for the version.
    • Coat with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
  4. Bolt
  5. High Pressure Side Refrigerant Line
  6. Low Pressure Side Refrigerant Line
  7. Bolt
  8. O-Ring
    • Replace. Refer to the Parts Information for the version.
    • Coat with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .
  9. A/C Compressor Regulator Valve -N280-
    • To check, use the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function. Refer to the appropriate Wiring Diagram(s).
      NOTE:

      Certain malfunctions at the A/C Compressor Regulator Valve A/C Compressor Regulator Valve -N280- (for example, a stuck valve or a short circuit in the coil) can lead to a complaint regarding the A/C compressor (A/C system is not cooling, the evaporator ices over, etc.). If the A/C Compressor Regulator Valve -N280- (and not the A/C compressor itself) is the cause, the A/C compressor can be serviced by replacing the A/C Compressor Regulator Valve -N280-. Refer to COMPONENTS, REPLACING - R134a or COMPONENTS, REPLACING (R1234yf) .

      The A/C Compressor Regulator Valve -N280- is not available as a replacement part for all A/C compressors. If the A/C Compressor Regulator Valve -N280- is not available as an individual A/C compressor part (different versions), then the entire A/C compressor must be replaced if there is a complaint.

  10. A/C Compressor
  11. Bolt
    • Tightening specification for steel bolts: 25 Nm
    • Tightening specification for aluminum bolts: 8 Nm +180°
    • Only use aluminum bolts once, then replace.
    • Quantity: 3
    • There are different versions.
  12. Belt Pulley with Overload Protection
  13. Alignment Sleeve
    • Quantity: 2