Manual:HUMMER Hummer H3 Base 2010Page:3307 / 37523



Measuring Frequency — 2010 Hummer H3 Base, Automatic Service Manual

Measuring Frequency

Special Tools 

EL 39200:  Digital Multimeter (DMM)

For equivalent regional tools, refer to Special Tools .

CAUTION: Refer to Test Probe Caution .

The following procedure determines the frequency of a signal.

NOTE: Connecting the Digital Multimeter (DMM) to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.
  1. Apply power to the circuit.
  2. Set the rotary dial of the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Press the Hz button on the DMM.
  6. The DMM will display the frequency measured.