Special Tool(S)
| 100-012 Slide Hammer | |
| 100-012-01 Slide Hammer Adapter | |
| 303-1069 Adapter, Wrench | |
| 308-375 Remover, Input and Output Seal |
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some illustrations may show the transmission removed for clarity.
- Disconnect the battery earth lead.
Refer to: SPECIFICATIONS .
- Refer to: SECONDARY BULKHEAD CENTRE PANEL - TDV6 3.0L DIESEL .
- Refer to: FRONT DRIVESHAFT - TDV6 3.0L DIESEL .
- Refer to: REAR DRIVESHAFT - TDV6 3.0L DIESEL .
Using a transmission jack, support the transmission.
- Secure the cable to the floor.
-
NOTE: Vehicles with DPF (Diesel Particulate Filter) installed only.
-
NOTE: Vehicles without diesel particulate filter (DPF).
-
WARNING: Be prepared to collect escaping fluids.CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
CAUTION: Only rotate the crankshaft clockwise.
-
WARNING: Make sure that the transmission is secured with suitable retaining straps.
Lower the rear of the transmission for access.
-
WARNING:
- This step requires the aid of another technician.
- Make sure that the transmission is secured with suitable retaining straps.
CAUTION: Make sure that the torque converter remains in the transmission.NOTE:- Do not disassemble further if the component is removed for access only.
- Secure the torque converter to the transmission using suitable cable ties.
-
CAUTION: Always plug any open connections to prevent contamination.
Special Tool(s): 303-1069
-
CAUTION: Do not carry out this step if a new transfer box is to be installed.
-
CAUTION:
- Care must be taken to avoid damage to the seal register and running surface.
- Do not carry out this step if a new transfer box is to be installed.
- Note the fitted position of the component prior to removal.
- Special Tool(s): 100-012 , 100-012-01 , 308-375
