Manual:AUDI A3 Premium, 4D Sedan 2015Page:46140 / 92758



Distance Regulation Control Module -J428- RETAINING PLATE, REMOVING AND INSTALLING, VERSION 1: Installing — 2015 Audi A3 Premium, 4D Sedan Service Manual

Distance Regulation Control Module -J428- RETAINING PLATE, REMOVING AND INSTALLING, VERSION 1: Installing

Install in the reverse order of removal. Note the following:

NOTE:

Replace the quick release.

The stud bolts in the bracket are pre-set. If necessary, correct the setting.

If the stud bolts were removed, then the clips on the distance regulation control module must be replaced. Refer to CLIP ON Distance Regulation Control Module -J428-, REPLACING, VERSION 1 .

-- Place the control module on a soft and clean surface.

-- Measure the dimension -a- at all stud bolts using the :VAS6335  and correct if necessary.

GWWA44-10089Courtesy of AUDI OF AMERICA, LLC
  • Dimension -a- = 44.3 mm.

-- Position the retaining plate -3- onto the distance regulation control module -1-.

GWWA27-10461Courtesy of AUDI OF AMERICA, LLC

-- Carefully press the new quick release -4- onto the stud bolt -2-.

-- Turn the quick release clockwise onto the retaining plate to the stop in direction of -arrow-.