Lower Transverse Link, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation is reverse of removal, Noting The Following:
- Note applied marking of eccentric bolt -B- to the subframe.
- Transverse link connection may only be carried out of dimension between wheel hub center and lower edge of wheel housing, measured before assembly, is achieved. Refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .
- On vehicles with electronically controlled damping (Audi magnetic ride), perform the function "Adapt the Control Position" with the Vehicle Diagnostic Tester.
- If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
- On vehicles with level control system sensor, perform headlamp basic setting. Refer to HEADLAMP, ADJUSTING / HEADLAMPS, CALIBRATING .
-- An axle alignment may be required. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .