Code
B297B
MITSUBISHI
B — Body
Trunklid cylinder open:OP cycle
AI status
Completed
Completed
100%
Causes
- Damaged or stuck trunk lid cylinder/actuator
- Failed open/position switch or sensor
- Broken, corroded or disconnected wiring/connectors to actuator or sensor
- Blown fuse or poor battery/ground connection
- Mechanical obstruction or binding in hinge/latch mechanism
- Control module or software fault
Symptoms
- Trunk lid does not fully open when activated by switch or keyfob
- Trunk lid opens slowly or intermittently stops during opening
- Control module stores B297B and may inhibit further open commands
- Possible clicking or motor noise at actuator that does not result in full travel
- Trunk position indicator inaccurate or not updating
What to check
- Attempt to reproduce failure and note conditions (cold start, after rain, with remote/manual)
- Scan vehicle memory for B297B and any related codes; record freeze frame data
- Visually inspect trunk lid actuator, wiring harness, connectors, and open/position switch for damage, corrosion or water intrusion
- Check battery voltage and ground integrity while attempting an open cycle
- Operate trunk open command while observing actuator: listen for motor, feel for movement, and note time to reach open position
Signal parameters
- Trunk open command (switch/keyfob) — expected to trigger actuator power
- Actuator supply voltage during open command (approx. battery voltage ~12V)
- Motor current draw during operation (spike when motor starts, steady during travel)
- Open/position switch signal state change when trunk reaches fully open
- Time/duration from command to open-position switch activation (should be within expected cycle time)
Diagnostic algorithm
- Reproduce the fault and clear the code, then attempt open cycle while monitoring for recurrence.
- Inspect connectors and wiring at trunk actuator and position switch; repair any corrosion, pin damage or loose terminals.
- With a multimeter, check for battery voltage at the actuator power feed while operating the open command. If no voltage, trace back to fuse/relay and control module output.
- Measure motor current when commanding open; no current suggests open circuit or failed motor, excessive current indicates mechanical bind.
- Verify the open-position switch changes state when trunk is physically moved to open position. Adjust or replace switch if it does not change reliably.
- Inspect hinge/latch and cylinder for binding, damage or debris; lubricate or repair mechanical interference.
- If wiring and actuator test good but code persists, check for control module faults or software updates and consult manufacturer service information before replacing modules.
- After repairs, clear codes and perform multiple open/close cycles to confirm proper operation and that B297B does not return.
Likely causes
- Actuator motor not receiving power during open command
- Open-position switch not changing state (failed or misaligned)
- Connector corrosion or broken wire in harness to trunk actuator
- Physical obstruction preventing full travel of the trunk lid
- Intermittent ground or low battery voltage causing incomplete cycle
Fault status
Status
Trunklid cylinder open: OP cycle — open operation did not complete or open-position signal not detected.
Repair difficulty: Medium
Diagnostic time: 0.5-1.5 hours
Similar codes
Repair manuals
Manual library for MITSUBISHI
406
Browse 406 MITSUBISHI manuals: repair procedures, diagnostics, wiring diagrams, component locations, service data and Labor Times by year, model and trim.
MITSUBISHI
-
MITSUBISHI: 2024
-
Outlander
- Black Edition, AWD
- Black Edition, AWD
- Black Edition, FWD
- Black Edition, FWD
- ES, AWD
- ES, AWD
- ES, FWD
- ES, FWD
- Platinum Edition
- Platinum Edition
- SE, AWD
- SE, AWD
- SE, FWD
- SE, FWD
- SEL, AWD
- SEL, AWD
- SEL, FWD
- SEL, FWD
- SEL Black Edition, AWD
- SEL Black Edition, AWD
- SEL Black Edition, FWD
- SEL Black Edition, FWD
-
Outlander PHEV
-
MITSUBISHI: 2023
-
Mirage
-
Mirage G4
-
Outlander
- 40th Anniversary
- 40th Anniversary
- Black Edition, AWD
- Black Edition, AWD
- Black Edition, FWD
- Black Edition, FWD
- ES, AWD
- ES, AWD
- ES, FWD
- ES, FWD
- Ralliart
- Ralliart
- SE, AWD
- SE, AWD
- SE, FWD
- SE, FWD
- SEL, AWD
- SEL, AWD
- SEL, FWD
- SEL, FWD
- SEL Black Edition, AWD
- SEL Black Edition, AWD
- SEL Black Edition, FWD
- SEL Black Edition, FWD
- SE Special Edition, AWD
- SE Special Edition, AWD
- SE Special Edition, FWD
- SE Special Edition, FWD
-
Outlander PHEV
-
MITSUBISHI: 2022
-
Eclipse Cross
- ES, AWD
- ES, AWD
- ES, FWD
- ES, FWD
- LE, AWD
- LE, AWD
- LE, FWD
- LE, FWD
- SE, AWD
- SE, AWD
- SE, FWD
- SE, FWD
- SEL, AWD
- SEL, AWD
- SEL, FWD
- SEL, FWD
- SEL Special Edition, AWD
- SEL Special Edition, AWD
- SEL Special Edition, FWD
- SEL Special Edition, FWD
- SE Special Edition, AWD
- SE Special Edition, AWD
- SE Special Edition, FWD
- SE Special Edition, FWD
-
-
MITSUBISHI: 2021
-
MITSUBISHI: 2020
Your experience will help others
+100 karma for a short comment :)
Was this AI description helpful?
Your feedback helps improve AI descriptions.
👍 Like
0
👎 Dislike
0
Send to email
